Power pack unit double scissor lift HSLTH series is used for scissor lift as hydraulic powerful source and control system. The power pack unit double scissor lift HSLTH series with zero leakage and double check valve to achieve the complete isolation of the two oil lines, the pressure in two oil piping will rise and down which does not interfere with each other, is the ideal hydraulic source for multi cylinder single lifting system; system of two cut-off valve for power system fault, safe and practical, and now the emergency oil return. The series of power units are widely used in large system of scissor lift.
- Power pack unit double scissor lift HSLTH series works for the S3 work system, it can not be continuous operation, on in 30 seconds and off in 270 seconds.
- The car lift hydraulic power unit must ensure that the oil clean without any impurities from cylinder, oil pipe, fittings and other hydraulic components.
- Hydraulic oil viscosity should be 15 ~ 68CST, should be clean and free of impurities, recommended the use of N46 number of hydraulic oil.
- This hydraulic system is suitable for vertical installation.
- The amount of oil in the tank is sufficient should be checked when to start the operating system at first time.
- The hydraulic oil should be changed after using operation at first 100 hours, then the replacement of hydraulic oil every 3000 hours.
- For requirement of different flow, pressure, motor power and other system parameters, please consult us.
Normal Ordering Code: HSLTH-220V-8L-2.7C-220B-1.5 *
(1) Hydraulic Power Pack=HSLTH
(2) Motor Voltage: 220VAC, 380VAC
(3) Oil Reservoir Volume: 8L, 12L, 14L, 16L, 20L, 22L, 25L
(4) Pump Displacement: 2.7ml/r; 3.2ml/r; 2.5ml/r; 3.7ml/r, 4.2ml/r
(5) Max. Pressure: 10MPa(100bar), 15MPa(150bar), 18MPa(180bar), 160MPa(160bar), 20MPa(200bar), 22MPa(220bar)
(6) Electric Motor Power: 1.5KW, 2.2KW, 3.0KW
(7) * : Further Information
(Check the chart below)
Note: For more information, please check the chart below